Filter
Top Products
24
The battery charger 1, 2
e battery charger unit is supplied with five plug attachments to
suit various types of domestic electrical sockets available worldwide.
Other types of socket will require a domestic socket converter.
Attach the chosen plug (fig 2, A) by sliding into position, ensur-
ing that the two electrical contact prongs on the charger correctly
enter the two contact sockets on the plug attachment. Removal is
by the reverse procedure.
Charging the battery
If attached, remove the protective cover (fig. 3, B) from the battery
by pulling outwards and upwards on the locking clip. Replace the
cover aer charging if you do not intend to attach the battery to
a camera immediately.
With the battery grip removed from the camera, insert the jack
plug from the battery charger into the socket (fig. 4, C) on the bat-
tery grip. Insert the battery charger into a standard (100–240V~
/50–60 Hz) domestic socket. e red LED indicator on the battery
charger signifies the following:
On (not flashing) = battery is charging
Slow flashing (0.8 Hz) = charging is complete and condition is being
maintained.
Or occasionally
Rapid flashing (3 Hz) = deeply discharged battery is charging
(with reduced current)
Please note that rapid flashing of the LED indicator is not to be
expected. e battery will not normally be so deeply discharged
because the camera will shut down automatically before complete
battery discharge takes place. e indicator might also flash rapidly
for a few moments in some instances when the charger is connected
to the electrical supply.
e normal indication is therefore either ‘not flashing’ or ‘slow
flashing’.
Attaching the battery to the camera
e rechargeable battery grip is attached and removed in the same
manner as the standard battery grip.
Please note if you want to use the rechargeable battery with an H1
model, the firmware in the camera must be version 8.2.2 or later
for the battery grip to function properly.
Rechargeable battery grip – general
• The battery should be charged before first time use.
• Maximum battery capacity is reached only after the battery has been charged
and discharged several times.
• The battery is an environmentally approved Li-ion type and has no ‘memory effect’
of practical importance. This means the battery can be charged before it is fully
discharged without loss of capacity or performance.
• The battery should be charged at an ambient temperature of 10 −30° C.
• When removing a battery from the charger and immediately replacing it with
another, allow a few seconds to elapse so that the charger can automatically reset
for the next charging procedure.
• It is perfectly normal for the battery to become warm when being charged.
• A slight temporary loss of battery performance might be noticed at very high or
low temperatures. Take the approriate measures if this is the case.
1
4
2 3
A
B
C