Filter
Top Products
Notes:
1. The graphics that follow designate the HSL connectors for the system unit as 0
and 1. These designations represent which set of connectors on your system
unit the HSL loop is connected to (for example B0 and B1).
2. These procedures are intended as a guide. Some steps in the following
procedures may vary depending on the number of HSL connectors you
received in your order. Make sure that you follow the configurations rules in
Table 4 on page 5.
Connecting your 5074 at the beginning of a loop
Use this procedure to connect your 5074 in the first position in a loop of expansion
units. In this procedure you will connect your 5074 between your system unit and
the expansion unit which is currently in the first position. These instructions refer
to the expansion unit which is currently in the first position as unit X as is shown
in Figure 5 and Figure 6.
Figure 5. HSL connections
Figure 6. SPCN connections
Chapter 2. Setting up your 5074 expansion unit 11