Filter
Top Products
__ 1. Open the back cover on your 5079. See Appendix A, “Removing the back
covers” on page 31 if you need instructions.
__ 2. Connect the cables to the 5079–002 (the upper unit). See Appendix B,
“Connector Locations” on page 35 if you need information about finding
connectors.
__ a. Connect a new HSL cable to HSL connector 1. If you have different
length cables, this cable should be the shortest one.
__ b. Connect a new SPCN cable to connector J16.
__ c. Connect the power cable. Do not plug into the wall outlet. If your
power cables for the 5079 are two different lengths, connect the
longer cable to 5079–002.
__ 3. Connect the cables to the 5079–001 (the lower unit).
__ a. Connect the HSL cable that you installed in step 2a to HSL
connector 0.
__ b. Connect another HSL cable to HSL connector 1.
__ c. Connect the SPCN cable that you installed in step 2b to SPCN
connector J15.
__ d. Connect another SPCN cable to connector J15.
__ e. Connect the power cable. Do not plug into the wall outlet. If your
power cables for the 5079 are two different lengths, connect the
shorter cable to 5079–001.
__ 4. Remove or open the back cover on your system unit.
__ 5. Remove or open the back cover on unit X.
__ 6. At unit X, remove the HSL cable from HSL connector 0. This cable is the
HSL cable that runs between unit X and your system unit.
__ 7. At unit X, remove the SPCN cable from connector J15. This cable is the
SPCN cable that runs between and your system unit.
__ 8. Connect the HSL cable from your system unit to the HSL connector 0 on
5079–002. This cable should now run between your system unit and your
5079–002.
__ 9. Connect the SPCN cable from your system unit to the SPCN connector J15
on 5079–002. This cable should now run between your system unit and
your 5079–002.
Figure 15. SPCN connections
Chapter 4. Setting up your 5079 Expansion Unit 23