Filter
Top Products
Chapter 6. Verifying Your New Configuration
Verify your new configuration by performing the following:
__ 1. Type strsst on the command line. Press Enter.
__ 2. Type your service tools userid and service tools password on the
System Service Tools (SST) Sign On display.
Press Enter.
__ 3. Select Start a service tool from the Start a Service Tools display and press
Enter.
__ 4. Select Hardware service manager on the Start a Service Tool display.
Press Enter.
__ 5. Select Packaging hardware resources (system, frames, cards...) on the
Hardware Service Manager display.
Press Enter.
Your new 0578, 5074, 5078 or 5079 expansion unit appears on the list.
Record the Frame ID and Resource name here:___________ , ___________. If
your expansion unit does not appear, you need to verify your installation
by performing these steps:
__ a. Make sure that you powered on your expansion unit.
__ b. Make sure that you installed the cables correctly. Refer to Chapter 2,
“Setting up your 5074 expansion unit” on page 9, Chapter 3, “Setting
up your 0578 expansion unit” on page 15 or Chapter 4, “Setting up
your 5079 Expansion Unit” on page 19.
__ 6. You can verify vital product data (VPD) for your new expansion unit:
__ a. Press F3 to return to the Hardware Service Manager display.
__ b. At the Hardware Service Manager display, select System power
control network (SPCN).
__ c. Press the Enter key twice.
__ d. To update VPD data, do the following:
1) If you installed a 5079, you need to find the Frame ID for both
5079–002 and 5079–001 and the system Serial Number.
2) You can also find the Frame ID by looking at the display on the
expansion unit. For example, if the Frame ID for your 5079–002
(the upper unit) is 4, a *04 will appear on the display.
__ e. Enter a 3 (Write VPD) for your expansion unit. Press Enter.
Example: If the Frame ID for your expansion unit is 2, enter option 3,asis
shown in the example below. Use the Frame ID with a 0 in the
Unit field.
© Copyright IBM Corp. 2000, 2002 29