Filter
Top Products
16
NS-DSC1110A 10 Megapixel Camera
www.insigniaproducts.com
Setting the metering function
This feature controls exposure metering in
recording still images.
To set the metering function:
1 Press MODE to switch to Photo mode.
2 Press MENU to open the Record menu.
3 Press / or /
to highlight Metering, then
press OK/DISP to open the submenu.
4 Press / or /
to select the setting you
want, then press OK/DISP. You can select:
• Center—Averages the light metered from the
entire frame, but gives greater weight to the
subject matter at the center.
• Multi—Divides the image into several zones
and measures the light in each zone for a
balanced exposure reading. Your camera
determines shooting conditions according to
the measured lighting pattern, and makes
exposure settings accordingly.
• Spot—Locks the spot metering frame to the
center of the LCD.
An icon that corresponds to the metering
mode selected will appear on the left side of
the LCD.
5 Press MENU again to close the menu.
Turning burst mode on or off
Burst mode allows for continuous shooting of
photos. Burst mode is not available in Video mode.
To turn burst mode on or off:
1 Press MODE to switch to Photo mode.
2 Press MENU to open the Record menu.
3 Press / or /
to highlight Burst Mode,
then press OK/DISP to open the submenu.
4 Press / or /
to select On or Off, then
press OK/DISP.
Note
The metering function can only be set when Simple
mode is set to Off.
Note
The burst mode setting can only be adjusted when
Simple mode is set to Off.
Metering
icon