Filter
Top Products
- 12 -
CV-M10BX/CV-M10RS
8.6. Locations of Jumper
Jumpers positions are shorted with a 0 ohm resistor or by a soldering between the 2 points. To remove the solder tin from
a jumper position, use a special tin remover such as desolder wick.
8.6.1. Location of Jumper on PK8189A
On this board the jumpers for HD/VD input, output and 75ohm termination are found.
8.6.2. Location of Jumper on PK8187A
On this board the jumpers for alternative outputs on the 12 pin connector are found.
JP3 JP1 JP7
JP6 JP4JP5
R20
R19
R21
R27
R26