Filter
Top Products
- 14 -
CV-M10BX/CV-M10RS
9. Internal adjustments on BX
For CV-M10BX there are internal potentiometers for adjusting the two video outputs. Do not touch these adjustments unless
you are familiar with video camera adjusting.
The potentiometers are found on the PK8206A board in CV-M10BX.
For CV-M10RS the same adjustments can be done via RS232C with the camera control tool.
See "10. CV-M10RS Camera Control Tool."
The adjustments are for the following functions:
Black level. Factory setting is 20 mVpp ±5 mV
Video 1 AGC level. Factory setting is 700 mVpp ±30 mV.
White clip level. Factory setting is 800mVpp ±20 mV
Video 1 and Video 2 gain. Factory setting to same video level on both outputs.
VSUB on the CCD sensor. Do not touch this adjustment.
9.1. Potentiometer locations on PK8206A
JP13
JP12
VR6: Video 2 Black Level
VR2: Video 1 Gain Level
VR5: Video 1 White Clip Level
VR1: CCD Vsub adjust. Do not touch.
VR3: Video 1 AGC Level
VR7: Video 1 Black Level
VR4: Video 2 White Clip Level
VR8: Video 2 Gain Level