Filter
Top Products
Page 13
TM-1020 Series Progressive Scan Shutter Cameras
Installation
2.2.7 Power Supplies and Power Cable Setup
2.2.7 (a) Power Supplies
The TM-1020 series camera requires 12V DC power that is obtained through the 12-pin connector
located on the rear panel of the camera. JAI, Inc. recommends the following power supplies:
PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply,
(No 12-pin connector) US Plug
PD-12UUP PD-12UU with12-pin connector US plug
PD-12UE PD-12UU European plug
(No 12-pin connector)
PD-12UEP PD-12UU with 12-pin connector European plug
For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP
power supplies are available with the 12-pin mating connector already attached to the leads from the
power supply. The PD-12UU and PD-12UE power supplies can be connected to the JAI, Inc. power
cable via a terminal strip or directly.
When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:
• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and
shorting.
• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
• All connections must be properly insulated to prevent shorting.
2.2.7 (b) JAI, Inc. Power Cables
If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out
diagram in “12-Pin Connector (LVDS/RS-422 version)” on page 6. The cable pin-out diagram is shown
in Figure 8 below. The color-coded leads use Gray for Ground and Yellow for +12V.