Filter
Top Products
EN
14
12:34:24
TAPE RECORDING
Time Code
During recording, a time code is recorded on the tape.
This code is to confirm the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion, the time code
begins counting from “00:00:00” (minute:second:frame).
If recording starts from the end of a previously recorded
scene, the time code continues from the last time code
number.
To perform Random Assemble Editing (੬ pg. 41 – 43),
time code is necessary. If during recording a blank
portion is left partway through the tape, the time code
is interrupted. When recording is resumed, the time
code starts counting up again from “00:00:00”. This
means the camcorder may record the same time codes
as those existing in a previously recorded scene. To
prevent this, perform “RECORDING FROM THE
MIDDLE OF A TAPE” in the following cases;
•When shooting again after playing back a recorded
tape.
•When power shuts off during shooting.
•When a tape is removed and re-inserted during
shooting.
•When shooting using a partially recorded tape.
•When shooting on a blank portion located partway
through the tape.
•When shooting again after shooting a scene then
opening/closing the cassette holder cover.
RECORDING FROM THE MIDDLE OF A TAPE
1 Play back a tape or use Blank Search (੬ pg. 15) to
find the spot at which you want to start recording, then
engage the Still Playback mode (੬ pg. 14, “Normal
Playback”).
2 Set the Power Switch @ to “ ” or “ ” while
pressing down the Lock Button $ located on the
switch, then start recording.
NOTES:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time code
indication does not move smoothly.
● The time code is displayed only when “TIME CODE” is
set to “ON” (
੬ pg. 35).
Frames
(30 frames = 1 second)
Seconds
Minutes
Frames are not displayed
during recording.
Normal Playback
1 Load a tape (੬ pg. 9).
2 Set the VIDEO/MEMORY Switch t to “VIDEO”,
then set the Power Switch @ to “ ” while pressing
down the Lock Button $ located on the switch. To start
playback, press
4
/6 !.
•To stop playback temporarily (Still Playback), press
4
/6 !.
•To stop playback, press 5 7.
•Turn the SHUTTLE SEARCH Ring #
counterclockwise (
2
) and release to rewind, or
clockwise (
3
) and release to fast-forward the tape
during Stop mode.
•High-speed picture search (Shuttle Search) is
possible by turning the SHUTTLE SEARCH Ring #
counterclockwise (
2
) or clockwise (
3
) during
playback (holding the SHUTTLE SEARCH Ring #
continues search until released).
•Press the Zoom Button T Y on the remote control to
zoom in (up to 44X*/50X**), or W T to zoom out. You
can also magnify a particular part of an image
(੬ pg. 39).
* GR-DX95/DX75 only
**GR-DX300 only
•At any time, pressing
4
/6 ! resumes normal
playback.
Slow-Motion Playback/Playback Special Effects/
Playback Zoom:
Available only with the remote control (੬ pg. 39)
To Control The Speaker Volume:
..... press VOL. + e to turn up the volume, or – w to
turn down the volume.
ATTENTION
During Shuttle Search, parts
of the picture may not be
clearly visible, particularly on
the left side of the screen.
TAPE PLAYBACK
Display