Filter
Top Products
EN
9
E
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its
legs to stabilize the camcorder. It is not advised to use
small sized tripods. This may cause damage to the unit
by falling over.
1 To attach the camcorder to a tripod, align the screw
to the mounting socket p on the camcorder. Then
tighten the screw clockwise. Some tripods are not
equipped with studs.
GETTING STARTED
Loading/Unloading A Cassette
The camcorder needs to be powered up to load or eject
a cassette.
1 Slide and hold OPEN/EJECT E in the direction of
the arrow then pull the cassette holder cover open until
it locks. The cassette holder opens automatically.
•Do not touch internal components.
2 Insert or remove a tape and press “PUSH HERE” to
close the cassette holder.
•Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely before
closing the cassette holder cover.
•When the battery’s charge is low, you may not be able
to close the cassette holder cover. Do not apply force.
Replace the battery with a fully charged one before
continuing.
3 Close the cassette holder cover firmly until it locks
into place.
To Protect Valuable Recordings:
Slide the erase protection tab on the back of the tape in the
direction of “SAVE”. This prevents the tape from being recorded
over. To record on this tape, slide the tab back to “REC” before
loading it.
Cassette holder
Cassette holder
cover
Make sure the window
side is facing out.
Tape
Recording mode
SP LP
30 min. 30 min. 45 min.
60 min. 60 min. 90 min.
80 min. 80 min. 120 min.
Approximate recording time
PUSH HERE
Be sure to press only the section labeled “PUSH HERE” to
close the cassette holder; touching other parts may cause your
finger to get caught in the cassette holder, resulting in injury or
product damage.
NOTES:
● The cassette holder cannot be opened unless a power
supply is attached.
Continued on next page.
p