Filter
Top Products
E32
5. Menu screen settings (continued)
Setting procedure
1.
Open the side switch panel, and press the [MENU] but-
ton for 2 seconds or longer. The [MENU] screen ap-
pears on the monitor screen.
* The [MENU (QUICK)] screen can be displayed by
pressing the [MENU] button for less than 2 seconds.
2.
Press the [UP] or [DOWN] button to select a menu item
(the menu item will be displayed in purple when se-
lected), then press the [SET] button to display the
submenu screen.
3.
In the submenu screen, press the [UP] or [DOWN] but-
ton in the same manner as above to select a submenu
item, then press the [SET] button. The setting will be
confirmed and registered to the memory.
The set value will be displayed in purple, indicating that
it can be changed.
4.
Use the [UP] and [DOWN] buttons to change to set
value, then press the [SET] button to confirm (the set
value will return to white).
MEMO
• Continuous pressing of the [UP] or [DOWN] button will
change the set value in increment of 10. Use this feature
when making large changes in value.
• Pressing the [MENU] button without pressing the [SET] but-
ton will return the setting to the previous value without mak-
ing changes.
5.
Press the [MENU] button twice to return to the normal
screen.
[UP]
[SET]
[DOWN]
[MENU]
UP/AW
SET
MENU
DOWN
1234
WHITE BALANCE screen
(example)
MENU screen
Inside window
Item
Set value
Change with
[UP] and
[DOWN] buttons
E33
Contents
Switched in accordance with the used lens.
AUTO: When using auto-iris lens.
MANUAL: • When using manual iris lens.
• Lens not mounted
• When using manual iris while auto-iris lens
is mounted.
*When the auto-iris lens cable is not connected to the
[LENS] connector, the setting automatically becomes
“MANUAL”.
Used to adjust the video level when auto-iris, ALC and
EEI are used,
Increasing the value: Raises the level
Decreasing the value: Lowers the level
Used to set the iris level when the IRIS MODE is set to
“MANUAL”.
Increasing the value: Opens the iris
Decreasing the value: Closes the iris
Menu contents
1 : EXPOSURE: .................
Used for settings related to the video level, such as iris, shutter, sensitivity, etc.
2 : WHITE BALANCE: ........ Used to make settings for color temperature and white balance.
3 : PROCESS: .................... Used to make settings for detail compensation, gamma, master
black, flare compensation, Auto Black Level (ABL), etc.
4 : LENS : ...........................
Sets the control method for the lens iris and lens focus, and zoom control method.
5 : SYSTEM SETTING: ...... Sets the screen display method and level of test pattern.
EXPOSURE screen
Item
IRIS MODE
Set Value
[AUTO]
MANUAL
-128
-127
:
[NORMAL]
:
126
127
[FULL]
SQUARE
SPOT
0
1
•
[128]
•
254
255
[ ] indicates the factory setting
FULL SQUARE SPOT
MEMO
During selection of
the detection area,
the detection area is
shown on the
screen connected to
the analog output.
AE LEVEL
AE AREA
IRIS
LEVEL
Detection
area
Detection
area
Detection area
MEMO
“----“ is displayed when auto-iris, ALC, and EEI are all set to
not operate.
Used to set the detection area for auto-iris. Switch
the setting in accordance with the conditions of use.