Filter
Top Products
E18
ANALOG OUT
IEEE1394
LENS
MD
CONTROL
REMOTE
DC IN
POWER
SEE INSTRUCTION MANUAL
VIDEO OUTPUT
TO CAMERAS(Y/C) OUTPUT
DC 12V=OUTPUT
EITHER
OUTPUT
MAX 1.25A
SEE INST-
RUCTION
MANUAL
AC 100V
AA-P700
AC
Connecting power
2. Before shooting (continued)
Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA
terminal of the AC adapter (AA-P700) connect the power cable (2m) which is provided.
AC adapter
Plug
Ring
Connect the end with
the white marking to
the AC adapter.
White marking
MEMO
Wait at least 10 seconds before turning the power switch back on, when it has just been turned off.
Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc.
CAUTION
• Be sure to use the AA-P700 power supply.
Before connecting power cable, make sure that the power switch on the AA-P700 is set to OFF.
Connecting with the power switch on may result in camera malfunction.
• When connected through the digital output (Connecting through digital output connector (page E14)),
power can be supplied from the PC but control of a motorized lens and analog output will not be
possible.
D
C
IN
POWER
[DC IN] connector
power cable
(provided)
[TO CAMERA]
connector
Ⅵ To reduce the emission of unwanted radio waves,
make sure to attach the provided clamp filter as
shown in the figure on the left.
Ⅵ Attach the clamp filter as close to the KY-F1030 as
possible as shown in the figure.
Connecting the IEEE1394 Cable
ⅥAfter inserting the plug com-
pletely, tighten the securing
ring.
Make sure white indication of
power cable comes to AA-
P700 side.
To [IEEE1394]
connector