Filter
Top Products
E39
Item
PIXEL COMP.
PIXEL
CHECK
PROCESS screen
Set Value
[OFF]
ON
LENS screen
Item
IRIS
IRIS LEVEL
When
“MANUAL” is
selected
SERVO SEL
FOCUS
When
“POSITION”
is
selected
ZOOM When
“POSITION”
is selected
Set Value
[AUTO]
MANUAL
0
1
•
[128]
•
255
[POSITION]
SPEED
0
1
•
[128]
•
255
0
1
•
[128]
•
255
Contents
Switched in accordance with the employed lens.
AUTO: When auto-iris lens is employed.
MANUAL: • When manual iris lens is employed.
• No lens mounted.
• When auto-iris lens is mounted but used as
manual iris lens.
* If the auto-iris lens cable is not connected to the [LENS]
connector, the setting automatically becomes “MANUAL”.
Sets the iris level when “MANUAL” is selected for the IRIS
MODE.
Increasing the value: Opens the iris
Decreasing the value: Closes the iris
Sets the lens control method.
Normally, use the “POSITION” setting.
* If the lens control cable is not connected to the [MD
CONTROL] connector, “----” is displayed.
Selects the focus position.
Increasing the value: Focus far away
Decreasing the value: Focus nearby
Selects the zoom position.
Increasing the value: Toward telephoto
Decreasing the value: Toward wide-angle
[ ] indicates the factory setting
Contents
Selects whether or not white spot compensation should
be performed.
OFF : White spot compensation not performed.
ON : White spot compensation performed.
੬ page E28 [White spot compensation]
Detects the positions of white spots.
੬ page E28 [White spot compensation]
[ ] indicates the factory setting