Filter
Top Products
10
Connection/Installation
Selecting a Mounting Method
The procedures vary according to the mounting
method. Mount the camera accordingly by
referring to the respective section.
Note:
● Be sure to put on protective glasses to
protect your eyes from falling objects when
mounting the camera to the ceiling.
● To mount the camera using an electrical box,
please consult the dealer shop from which
the camera is purchased or any nearby JVC
Service Centers.
Embedding the Camera into the Ceiling
T The camera can be mounted to ceilings with
a thickness between 9.5 mm and 22 mm.
Ⅵ Preparation
1 Make a hole in the ceiling (R120 mm)
2 Pull out the cables from the hole in
the ceiling
Pull out the fall prevention wire, LAN cable,
power cable, alarm cable, and audio cable that
are attached to the ceiling slab from the hole.
(Fall prevention wire is not provided)
Note:
● Take note of the length, strength, pull and
material (insulation) of the fall prevention
wire.
● The inner diameter of the ring section of the
fall prevention wire to be mounted to the
camera should be betweenR3.1 mm and R5.5
mm, and the outer diameter not larger than
R9 mm.
3 Remove the dome cover
Turn the dome cover in the anti-clockwise
direction to remove it. To prevent damage to the
dome cover, a protection sheet is affixed.
Mounting the Camera
Mounting Methods
ⅷ Embedding into the ceiling (A page 10)
ⅷ Mounting directly to the ceiling or the
wall (A [READ ME FIRST])
ⅷ Mounting with the cables pulled out
from the side (A page 12)
Warning
● Special attention is required when
mounting the camera to a wall or ceiling.
Make sure that the mounting work is
performed by a specialist. Improper
mounting may cause the camera to fall off
and result in injuries.
● We are not liable for any damage, injury or
other problems caused by a camera that
has fallen off due to failure to follow the
installation instructions and improper
mounting. Pay careful attention during
mounting.
● To prevent the camera from falling off,
mount it to a firm place (ceiling slab or
channel) using a fall prevention wire.
● Take note of the length, strength, pull and
material (insulation) of the fall prevention
wire.
● Insufficient tightening of the mounting
screws and nuts may cause the camera to
fall off. Make sure that there are properly
and firmly tightened.
● Do not mount the camera near lighting
equipment that may be heated up to a high
temperature, such as a spotlight. This may
result in malfunction of the equipment or
cause fire.
1
2
LAN cable
Approx. 100 mm
R120 mm
Fall prevention wire
(Not supplied)
Cables (power cable,
alarm cable, audio
cable, etc.)
Dome cover
protective sheet