Filter
Top Products
10
Introduction
Camera unit
A
Mounting hole (elliptical) ן 4
Use these when mounting the camera to the
electrical box.
(A Pg. 22)
B Mounting hole (round) ן 4
Use these when mounting the camera to the
ceiling or wall. (A Pg. 20)(A Pg. 22)
C Outer case
Use this in the following cases:
● When mounting the camera directly to the
ceiling or on the wall.(A Pg. 20)
● When mounting the camera to the electrical
box. (A Pg. 22)
D Dome cover
The dome cover is fragile. Take care when
handling it.
E Inner dome
Before mounting the camera, remove it and
perform image angle setting.
(A Pg. 18)(A Pg. 20)
F Operation check indicator
[Status] Status indicator
This indicator appears blinking when the power
is turned on and turns off when the camera
startup is completed. Check the camera or the
connected device if the indicator remains
blinking when the camera is in use.
[Link] Link indicator
This indicator lights up when the camera is
linked or connected to the network.
[Act] Activity indicator
This indicator lights up during an activity such as
data transmission or reception.
G Cable ejector hole
This is used for pulling cables from the side of
the camera unit without drilling a hole in the
ceiling.
(A Pg. 22)
Name and Function of Parts
Status
Act
Link
B
D
C
A
I
H
E
F
G
A
B
VN-C215_EN.book Page 10 Monday, November 27, 2006 9:52 AM