Filter
Top Products
22
Setup
Mount by allowing the cable to exit from
the side
You can also mount the camera on a ceiling or
wall by pulling the cables horizontally instead of
drilling a hole.
The basic mounting method is the same as
eMounting the camera directly on a ceiling or
alongside a wallf (A Pg. 20).
1.Remove the lid of the cable ejector hole
and divide the dotted line section of the lid
with a longnose pliers.
2.Mount the outer case on the ceiling or
wall.
3.Pull out the cables from the cable ejector
hole.
4.Connect the cables. (A Pg. 20)
5.Close the lid of the cable ejector hole.
Mounting the camera to the electrical
box
Note：
● Before mounting the camera to electrical
boxes, please refer to local building codes for
box type to use for low-voltage wiring.
Ⅵ Connecting
1.Align (j) with the shooting direction when
mounting the outer case to the electrical box
2.Follow steps 2 to 6 of AMount by allowing
the cable to exit from the sideB[Connection]
(A Pg. 20)
Mounting the Camera
(continued)
1
2
Divide
Cable ejector hole
5
F
RO
NT
UP
Outer case
mounting screws
Align with shooting direction
Less than 3 mm
VN-C215_EN.book Page 22 Monday, November 27, 2006 9:52 AM