Filter
Top Products
16
Connection / Installation
Connect the camera to a hub or computer using
a LAN cable.
Ⅵ When connecting to a hub
Make use of a straight cable.
Ⅵ When connecting to a computer
Make use of a cross cable.
Caution:
● However, cross cables cannot be used with
some computer models. When connecting
VN-V25U directly to a computer, check the
computer’s LAN specifications in advance.
Note:
● Make use of a Category 5 (or higher) cable
when 100BASE-TX is used.
● To distribute images to the network, set the
[MONITOR OUT] switch at the side of this
product to AOFFB.
This terminal is used for adjusting the camera
angle during installation. Connect it to devices
such as a video monitor using a video cable
(RCA).
Caution:
● A longer cable extension distance causes
signals to be attenuated, image resolution to
deteriorate and noise to increase.
Note:
● Select the signal system for the monitor
output using the [MONITOR OUT] switch at
the side of this product. (ANTSCB or APALB)
After adjusting the camera angle, set the
switch to AOFFB. After changing the switch
settings, press the Reset button to reboot the
camera.
LAN Cable Connection
Cable to use
● Shielded cable
● Length of 100 m or shorter
CAUTION
:NEVERUSE
PoE
AND
AC24V
ATTHE SAMETIME
DONOTCONNECT TOTHETELEPHONE NETWORK
SEEINSTRUCTIONMANUAL
CLASS2ONLYFORUSA
ISOLATEDPOWERONLY
FOREUROPEANDOTHER
MONITOR
OUT
10BASE-T/
100BASE-TX
PUSH
OUTPUT
INPUT
2
AC24V
1
PoE
G 2121
ALARM
STATUS
MONITOROUT
IRIS
PAL OFF NTSC
RESET
[MONITOR OUT] Switch
Monitor Signal Output Terminal
Connection
CAUTION
:NEVERUSE
PoE
AND
AC24V
ATTHE SAMETIME
DONOTCONNECT TOTHETELEPHONE NETWORK
SEEINSTRUCTIONMANUAL
CLASS2ONLYFORUSA
ISOLATEDPOWERONLY
FOREUROPEANDOTHER
MONITOR
OUT
10BASE-T/
100BASE-TX
PUSH
OUTPUT
INPUT
2
AC24V
1
PoE
G 2121
ALARM
VN-V25U_EN.book Page 16 Friday, November 2, 2007 11:26 PM