Filter
Top Products
19
This product comes with an inner tripod base at
the bottom surface. You can use the inner tripod
base by removing the camera mounting bracket
that is attached to the bottom surface. Mount this
product to the miniature housing using the screw
hole of the inner tripod base.
Bottom Surface
Warning
● Special attention is required when mounting
the camera to a wall or ceiling. Users
should get professional contractors to
perform mounting operations instead of
doing it themselves. Failure to do so may
cause the camera to fall off and result in
injuries or accidents.
● When mounting the camera to a fixer or
rotating platform, ensure that the camera is
firmly mounted by using the anti-rotation
holes to prevent it from falling off.
● To prevent the camera from falling off,
ensure that it is connected to a firm place
(ceiling slab or channel) using a fall
prevention wire.
● Pay also careful attention to the length,
strength, wiring, and material (insulating
properties) of the fall prevention wire to be
used. The length used should be as short
as possible within the permissible range of
the mounting length. The wire should be
strong enough to withstand the total weight
of this product and the fixer. (Pay also
attention to the finishing at the end of the
wire.)
● Mount the fall prevention wire using the
black screw at the rear of the camera unit.
● Designated screw for fastening of fall
prevention wire (M3 x 6 mm): Screws
beyond the specified length must not be
used as doing so may damage the interior.
Mounting to the Housing
Using the Inner Tripod Base
Inner Tripod Base
Camera Mounting
Bracket
Remove the screws for the bracket (2 pcs)
Inner Tripod Base Screw Hole (1/4-20UNC)
VN-V25U_EN.book Page 19 Friday, November 2, 2007 11:26 PM