Filter
Top Products
Photo Printer 4700 Series 17
Installing the Printer Drivers
The KODAK Photo Printer 4700 Printer Driver for WINDOWS 95 and
WINDOWS 98 (referred to in this guide as WINDOWS 95/98 printer driver) and
the KODAK Photo Printer 4700 Printer Driver for WINDOWS NT 4.0 (referred
to in this guide as WINDOWS NT 4.0 printer driver) are included with the
printer.
NOTE: To use these printer drivers you must have one of the following
operating systems: WINDOWS 95 (OEM Service Release 2),
WINDOWS 98, or WINDOWS NT 4.0 with a minimum of Service
Pack 4.
Installing the WINDOWS 95/98 Printer Driver
IMPORTANT: The WINDOWS 95/98 printer driver requires the parallel port
mode of your host computer to be ECP-compatible. Before you
install this driver, you may need to configure the parallel port
mode of your host computer to ECP mode.
To configure the parallel port mode of your host computer to be
ECP-compatible:
NOTE: Different computers have different BIOS configurations. Therefore, the
following steps only give you a general guideline for configuring the
BIOS. You may need the assistance of your system administrator to
perform this task.
1. Run your computer’s Setup program. (Typically, to do this you click a function
key or the Delete key during the boot-up of your system.) Open the Main
Page.
2. Follow the instructions on the Main Page to navigate to the page that lists your
Parallel Port Type.
3. If necessary, change your Parallel Port Type to ECP mode.
4. Save and exit the Setup Program per your computer manufacturer’s
instructions.
The BIOS automatically updates your Parallel Port Mode and restarts the
system.
You are now ready to install the printer driver.
To install the printer driver:
1. To start the Add Printer Wizard do one of the following:
• Click Start, point to Settings, click Printers, and then double-click the Add
Printer icon.
Or
• Insert the CD that came with your printer into your CD-ROM drive, select
your language from the choices that appear on the screen, and then click
Printer Drivers.
If the screen does not appear, double-click My Computer, then double-click
your CD-ROM drive.