Kodak 4700 Photo Printer User Manual


 
Photo Printer 4700 Series v
Regulatory and Safety Information
This section lists important regulatory and safety information for the
KODAK Photo Printer 4700 Series.
Radio Frequency Interference
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
reposition or relocate the receiving antenna.
increase the separation between the equipment and the receiver.
connect the equipment to an outlet on a circuit that is different from the one to
which the receiver is connected.
consult the dealer or an experienced radio/TV technician for help.
Requirements of the EMC directive 89/336/EEC were met through compliance
with the following:
EN 55022: 94 (class B) with Amendments A1:95 and A2:97
EN 50082 - 1 (European - EU) consists of:
EN 61000-4-2:95ESD
EN 61000-4-3:95rf immunity
EN 61000-4-4:95EFT
EN 61000-3-2 Harmonics
EN 61000-3-3 Flicker
Changes or modifications not expressly approved by the party responsible for
compliance could void the users authority to operate the equipment.
This is a Class B product based on the standard of the Voluntary Control Council
for interference from Information Technology Equipment (VCCI). If this is used
near a radio or television receiver in a domestic environment, it may cause radio
interference. Install and use the equipment according to the instruction manual.