Filter
Top Products
Operating the Printer
2-3
Printer Settings
Use the operator panel buttons to review and change printer
settings.
1. Press Menu to enter Setup Mode.
2. Press Menu repeatedly to scroll through the printer settings.
3. Press
+/- to scroll through selections.
4. Press Enter to initiate an action or accept a change.
5. Press Clear to exit Setup Mode.
8810 Photo Printer
Power
Ready
Error
Menu
Enter Paper Rewind/Clear
Paper Advance
Printer settings
are displayed here
3
1,2
4 5
Display Description
Ready The printer is on and ready to make prints.
Energysave Mode When selected, press Enter, then
+ or - to enable or disable
Energy Save mode (the default is off). When enabled, to
conserve power, the printer does not maintain printing
temperature when idle. The printer takes additional time to
warm-up before it starts printing.
Test Print Mode When selected, press Enter to make a test print. See “Making a
Test Print” on page 1-9.
Remain =
XXX/YYY
XXX represents how many remaining prints you can make with
the current paper roll. YYY represents the total number of
prints on a paper roll. The counter is reset each time you press
Paper Rewind.
Printed = XXXXXX XXXXXX represents the total number of prints made since the
printer was manufactured. This counter cannot be reset.
Donor = XXX[%] XXX[%] represents the percentage of the installed ribbon that
is available for making prints.
Main Firm = XX . YY XX . YY represents the printer control firmware version
number.
DSP Firm = XX . YY XX . YY represents the image processing firmware version
number.
USB Firm = XX . YY XX . YY represents the USB firmware version number.
TABLE Firm = XX .
YY
XX . YY represents the print parameter table version number.