Filter
Top Products
Troubleshooting
46
Camera ready light status
Status Cause Solution
Ready light does not turn
on and the camera does
not work.
Camera is not turned on. Turn on the camera
(page 4).
Battery is exhausted. Recharge the battery or install a
new one (
page 2).
Mode dial was on when
batteries were reloaded.
Turn Mode dial off, then back
on.
Ready light blinks green. Picture is being
processed and saved to
the camera.
Camera is operating normally.
Ready light blinks
orange.
Flash is not charged. Wait. Resume picture taking
when the light stops blinking
and turns off.
Auto exposure or
auto-focus are not
locked.
Release the Shutter button and
recompose the picture.
Ready light blinks red and
camera turns off.
Battery is low or
exhausted.
Recharge the battery or install a
new one (
page 2).
Ready light glows steady
red.
Camera’s internal
memory or card is full.
Transfer pictures to the
computer (
page 38), delete
pictures from the camera
(
page 25), switch storage
locations (page 20), or insert a
card with available memory
(
page 7).
Camera processing
memory is full.
Wait. Resume picture taking
when the light turns off.
Card is read-only. Change storage location to
internal memory (
page 20), or
use a different card.
Ready light glows steady
green
Shutter button is pressed
halfway down. Focus and
exposure are set.
Camera is operating normally.
Ready light glows steady
orange
The Mode dial is set to
Favorites.
Camera is operating normally.