Filter
Top Products
65
Chapter 9
Stored pictures are
damaged.
The card was removed
when the card access
light was blinking.
Make sure the card access
light is not blinking before
removing the card.
Pictures remaining
number does not
decrease after
taking a picture.
Picture does not take up
sufficient space to
decrease the picture
remaining number.
The camera is operating
normally. Continue taking
pictures.
Picture is not clear. The lens is dirty. Clean the lens (page 80).
Subject too close when
taking picture.
Move so there is at least 1.6
ft (0.5 m) between the
camera and the subject. Or
use the Close-Up setting
(page 17).
Subject or the camera
moved while the picture
was taken.
Hold the camera steady
while taking the picture.
The subject is too far
away for the flash to be
effective.
Move so there is no more
than 7.5 ft (2.3 m) between
the camera and the subject.
Slide show does
not run on external
video device.
Video Out setting is
incorrect.
Adjust the camera Video Out
setting (NTSC or PAL,
page 46).
External device is set
incorrectly.
Refer to the external device
user’s guide.
Camera
Problem Cause Solution