Filter
Top Products
93
Appendix
Appendix
Troubleshooting
Symptom Cause Remedy
LCD doesn’t appear.
Battery power is depleted or the
battery pack is not inserted.
Replace the battery pack with a
new one.
The auto-off function has
operated to turn power off.
(page 82)
Press the POWER button again
to turn power ON.
Setting of power-save function
may cause camera to enter
sleep mode when it is inactive
for set period.
Press the shutter button
halfway, or press any other
function buttons to return the
camera to normal operating
condition. Since camera
response differs depending on
the setting of the Power-Save
function, consult page 82 for
details.
The LCD monitor is turned off. Press the DISP button to turn
on the LCD monitor.
A strong magnet or other
electromagnetic generator is
located too near the camera.
Move the camera away from the
magnet or electromagnetic
field. After that, the LCD doesn’t
display, remove the battery pack
once and reinstall it in the
original location.
The number of images
recordable does not
change when a picture is
taken.
The file size of the recorded
image was very small.
File size and number of pictures
recordable differ depending on
the image quality setting and
subject conditions; not a
malfunction.
Image cannot be erased;
“ ” mark appears.
The image is protected. Release the image protect
function. (page 70)
The number of recordable
images didn’t change when
an image was erased.
The size of the erased image
file was very small.
File size and number of
recordable pictures differ
depending on image quality
mode and subject conditions;
not a malfunction.
All images were deleted
and the message [NO
IMAGE] appears.
However, the number of
recordable frames is
very few.
Some image files are stored
in the area other than the
folder [***KCBOX] in the
memory card.
There are some files named
other than [kif_****].
Copy the image files or
other necessary files in the
PC or other medias and
format the memory card.
00_8CQ.book Page 93 Wednesday, May 14, 2003 8:10 PM