Filter
Top Products
Recording
25
Motion Recording
Use Motion Recording to have the system only record when motion is detected by one of the
cameras. The camera that appears on-screen is the only camera that is recording.
To enable Motion Recording:
1. Press Motion on the remote control or the RECORD—A button on the wireless receiver. A
blue LED will light up beneath RECORD—A on the receiver.
2. Perform one of the following:
Enable Quad Mode (
recommended
): Press the Quad button. When motion is detected,
the system will display the triggered camera on-screen.
When motion recording is
complete, the view will return to Quad Mode.
Enable Auto Sequence Viewing Mode: Press the CHANNEL—A button. When motion is
detected, the system will display the triggered camera on-screen. When motion
recording is over, Auto Sequence Viewing Mode will continue as normal.
Change channels manually: Press the CHANNEL—M button on the wireless receiver or
remote control to select a channel.
3. Press Motion on the remote control or the RECORD—A button on the wireless receiver
again to stop Motion Recording. The blue LED will turn off on the receiver.
The “REC” indicator will
only
appear when motion is detected by one of the cameras on-screen.
By default, the system is set to record for 15 seconds after the triggered motion event. For
details on adjusting the motion recording time, see “Trigger Record” on page 35.
Figure 7.3 Recording triggered by motion during the Motion Recording
R
R
E
E
C
C
A
B
ATTENTION: If you manually select a channel while the system is in Motion Recording
Mode, motion recording will
ONLY
apply to the selected channel
. For example, with
Motion Recording enabled, you manually select channel 3; if motion were to occur in
view of camera 1, the system would NOT RECORD video from channel 1.