Nikon 1797 Digital Camera User Manual


 
137
Filters
Nikon filters can be divided into four types: screw-in, drop-in,
rear-interchange and slip-in type. As shown in the table on page
138, there are Nikon filters available for use with color and
black-and-white film, color film only, black-and-white film only
and for light with a wavelength in the 300nm to 950nm range.
Nikon offers such a wide variety because photographic needs
vary. For example, a color-temperature converting filter can
balance the color temperature of the light and your film. Filters
for black-and-white film alter contrasts and tones to suit your
purposes. Polarizing filters reduce the amount of light reflected
from non-metallic surfaces like glass and water. And ND
(Neutral Density) filters limit the light entering the camera and are
useful on bright, sunny days.
With the F5, filter factor need not be considered except for ND
400x and X1 filters and when Spot Metering is selected.
Compensate exposure –2/3 EV when using ND 400x filter and
+1 EV when using X1 filter.
Note that when special filters available from manufacturers other
than Nikon are used, autofocus or electronic rangefinder may
not operate properly.
•Use circular-polarizing filter C-PL instead of polarizing filter
Polar. Polarizing filter cannot be used with the F5.
•Use NC filter when using the filter to protect the lens.
•Moire may occur when shooting subject against bright light or
if a bright light source is in the frame. Remove the filter before
shooting in this case.
•Use Center-Weighted Metering when using a filter with filter
factor such as ND 8x or ND 4x, or a filter for black-and-white
film. The effect for the 3D Color Matrix Metering may not be
fully obtained with these filters.
P400 (E) 02.12.27 6:42 PM Page 137