Nikon 1797 Digital Camera User Manual


 
89
7 AE Lock when shutter release button is lightly pressed:
At the default setting, exposure does not lock when the
shutter release button is lightly pressed. To lock exposure
when the shutter release button is lightly pressed, select
7-1 in Custom Setting.
8 Auto film loading when camera back is closed: At the
default setting, loaded film is advanced to frame #1 when
the camera back is closed and the shutter release button is
fully depressed once. By selecting 8-1 in Custom Setting,
film automatically advances to frame #1 when the camera
back is closed after film loading.
9 Film advance speed in CH: To change the film advance
speed to 6 fps from 7.4 fps with AA-type alkaline or lithium
batteries or 8 fps with Ni-MH Battery Unit in (CH)
Continuous High-Speed film advance mode, select CH6.
10 Film advance speed in CL: To change the film advance
speed to 5 fps or 4 fps from 3 fps in (CL) Continuous Low-
Speed film advance mode, select CL5 or CL4.
11 Alert LED in buLb exposure: To enable alert LED to blink
during buLb exposure, select 11-1.
12 Auto film stop: At the default setting, film advances until
the end of the film roll is reached. To stop film advance at
frame number 35 or 36, select E35 or E36.
13 Multiple exposure: Multiple exposure mode is automati-
cally canceled when the second shot is taken. To continue
multiple exposure after the second shot, select 13-1.
14 Center-Weighted Metering: 75% of the meter’s sensitivity
is concentrated in the 12mm-dia. circle within the viewfinder
and 25% outside this circle in Center-Weighted Metering.
To change the size of the circle to 8mm, 15mm, 20mm,
average on entire viewfinder or create a custom-size (by
Computer Link) diameter, select C 8, C15, C20, A or PC.
15 Time delay for auto meter-switch-off: Camera’s meter
remains on approximately 8 seconds after the shutter
release button is pressed. To change the delay time to 4
sec., 16 sec. or 32 sec., select L 4, L 16 or L32.
P400 (E) 02.12.27 6:42 PM Page 89