Nikon 26358 Digital Camera User Manual


 
E22
Transferring Images to Your Smart Device
Reference Section
4 Position the camera near the smart device while the Searching...
screen is displayed.
5 Wait for the camera to detect the smart device.
If the “Activate Wi-Fi and select the camera SSID.” message
is displayed when you are using an iOS smart device, follow
the procedure below to configure the settings.
- Make sure the smart device’s Wi-Fi (wireless LAN)
function is on. If the Wi-Fi (wireless LAN) function is off,
turn it on.
- In the network list displayed on the smart device when the
smart device’s Wi-Fi (wireless LAN) function is turned on,
select the network SSID that is displayed on the camera
screen.
After the settings are complete, display the Connect to
S800c application screen again.
When the camera detects the smart device, the authentication screen is displayed.
6 Confirm that the numbers on the camera screen
match those on the smart device screen.
If the numbers match, proceed to the next step.
7 Tap OK on both screens.
The simple setup complete screen is displayed. Tap OK to complete the settings.
When using an iOS smart device, the Install Profile screen is displayed. The profile
starts installing automatically. Wait until the installation is complete.
- If JavaScript is disabled, the settings cannot be completed. Enable JavaScript in the
default browser application.
- If the profile installation is canceled before completion, perform the simple setup
procedure again.
- If the settings are not completed properly, uninstall the profile and install it again.
Simple setup
Upload to smart device
Searching…
15
:
30
Cancel
OK
Simple setup
Upload to smart device
Confirm that the number displayed by the
smart device matches the 4-digit number
displayed below.
15
:
30