Filter
Top Products
Inverse color mode
z
Bright lighting is required in
Inverse Color
mode when checking negative film on a Slide Copy Adapter. If the lighting is
insufficient, the image on the Monitor appears too bright. If the image is affected by noise (interference), set the Image
Sharpening to
Off
or
Low
.
z
Inverse Color
mode is only intended for checking negative film, and Image quality varies significantly depending on
the type or manufacturer of the film being used. To obtain high-quality images, use of a film scanner such as the Nikon
COOLSCAN is recommended.
NOTE :
Lens setting
z
The built-in Speedlight does not fire when the Lens settings is set to
Fisheye 1
,
Fisheye 2
or
Slide Copy Adptr
. The
Flash Cancel indication is displayed on the Control panel and Monitor.
z
Refer to the instruction manual for the optional lens converter or Slide Copy Adapter for details.
The
Lens
setting indication is displayed on the Monitor when a
Lens
setting other than Normal is selected.
When
Fisheye 1
is selected, the Infinity and Center-Weighted Metering indications are also displayed on the
Monitor.
When
Slide Copy Adptr
is selected, the
Macro
and
Less Contrast
indications are also displayed on the
Monitor.
User setting
The camera can "memorize" up to three combinations of settings, including White Balance, Metering, Continuous, Best
Positive
Setting for color slide film
Inverse Color
Setting for negative film
Pa
g
e 83 of 136
N
ikon COOLPIX995 Di
g
ital Camera
3/15/2002htt
p
://www.livemanuals.com/
p
acka
g
es/
p
roducts/NK002/2136/manual/fullmanual.html