Filter
Top Products
9998
TroubleshootingNotes on Batteries
•Use four AA-type alkaline-manganese or lithium batteries
Two 3V lithium batteries (CR123A or DL123A) can be used with optional 3V
Lithium Battery Holder MS-13. With Multi-Power High Speed Battery Pack
MB-15, six 1.5V alkaline-manganese or lithium batteries, or Ni-MH battery MN-15
can be used to power the F100.
•Change the batteries well before the end of their life and prepare spare batteries
before important photographic occasions.
•Turn the camera power off when changing batteries
Turn the camera power off before changing batteries and insert the batteries with
+ and – ends positioned correctly.
•Stains on the battery poles may cause lack of contact. Wipe the batteries well
with a dry cloth before installing.
•Use fresh batteries at low temperatures
Battery power diminishes at extremely low temperatures and the camera may not
function properly with old batteries. Use a fresh set of batteries at low
temperatures, keep spare batteries warm, and use them alternately.
•Film advance speed lowers and number of usable film roll becomes less at low
temperatures. However, battery power may recover when the temperature
returns to normal.
•Do not throw batteries into a fire or short circuit batteries
Do not throw batteries into a fire. Do not short, disassemble, heat or charge
batteries.
WARNING
Do not leave
Keep batteries out of children’s
reach.
If someone accidentally swallows batteries,
call a doctor immediately.
LCD panel Viewfinder
ƒEE blinks ƒEE blinks
M appears —
M blinks —
M and Err Err blinks
blink
ƒ-- appears ƒ-- appears
Err and E blink Err and
E blink
a, s, and Err blinks
Err blink
E blinks when E blinks when
exposure meter exposure meter
is turned on is turned on
End blinks End blinks
— ? blinks
Cause
•CPU Nikkor lens (other
than G-type) is not set
to its minimum
aperture.
•Batteries are nearing
exhaustion.
•Batteries are just about
exhausted.
•Batteries are
exhausted during film
rewind.
•Non-CPU lens is
attached or lens is not
attached.
•Film is not correctly
advanced.
•Film speed is set to DX
and non-DX-coded film
is loaded.
•Film remains in the
camera after film
rewind is complete.
•The end of the film roll
has been reached.
•Autofocus is not
possible.
Page
18
17
17
17
18, 32
21
21, 34
29
29
27
Remedy
•Set lens to minimum
aperture.
•Have fresh ones ready.
•Turn the power off and
replace batteries with
new ones.
• Replace batteries with
new ones or recharge
batteries and turn the
power on again. If this
warning appears
frequently, contact
authorized Nikon dealer
or service center.
• Attach CPU lens (except
IX-Nikkor).With a non-
CPU lens, set the
exposure mode to A or
M and set the aperture
with lens’ aperture ring.
•Reload film.
•Load DX-coded film or
set the film speed
manually.
•Remove the film
cartridge.
•Rewind film by
pressing the two film
rewind buttons „.
•Focus manually.
Miscellaneous
P500 (E) 02.12.27 5:48 PM Page 98