134
Caring for the Camera
Technical Notes
B The Self-timer Lamp/AF-assist Illuminator LED
The light-emitting diode (LED; A4, 33, 123) used in the self-timer
lamp/AF-assist illuminator conforms to the following IEC
standard:
C The Battery
• Check the battery level when taking the camera out, and charge the battery if necessary (A14).
Do not continue charging once the battery is fully charged, as this will result in reduced battery
performance. If possible, carry a fully-charged spare battery when taking pictures on important
occasions.
• Do not use the battery at ambient temperatures below 0 °C (32 °F) or above 40 °C (104 °F). During
charging, the temperature should be in the vicinity of 5 to 35 °C (41 to 95 °F). Note that the battery
may become hot during use; wait for the battery to cool before charging. Failure to observe these
precautions could damage the battery, impair its performance or prevent it from charging
normally.
• On cold days, the capacity of batteries tends to decrease. Be sure that the battery is fully charged
before heading outside to take pictures in cold weather. Keep spare batteries in a warm place and
exchange as necessary. Once warmed, a cold battery may recover some of its charge.
• Dirt on the battery terminals can prevent the camera from functioning.
• When the battery is not in use, remove it from the camera or battery charger and replace the
terminal cover. The camera and battery charger draw minute amounts of current even when off; if
left in place, the battery could be drained to the point that it no longer functions. Turning the
camera on or off while the battery is exhausted can result in reduced battery life. If the battery will
not be used for an extended period, store it in a cool (15 to 25 °C / 59 to 77 °F), dry place. Recharge
it at least once a year and run it flat before returning it to storage.
• Replace the battery when it no longer holds a charge. Used batteries are a valuable resource.
Please recycle used batteries in accordance with local regulations.