Olympus 262901 Camcorder User Manual


 
56
EN
Flash shooting
3
3
The built-in ash can be set manually as required. The built-in ash can be used
for ash photography in a variety of shooting conditions.
Using a ash ( ash photography)
1
Slide the ash switch to raise the ash.
2
Press the # button (I) to display options.
3
Use HI to choose a ash mode and press Q.
The options available and the order in which they are displayed vary depending on
the shooting mode. g “Flash modes that can be set by shooting mode” (P. 104)
AUTO Auto ash
The ash res automatically in low light or
backlight conditions.
#
Fill-in ash
The ash res regardless of the light conditions.
$
Flash off The ash does not re.
*1
!/H
Red-eye reduction
ash
This function allows you to reduce the red-eye
phenomenon. In S and M mode, the ash
always res.
#SLOW
Slow synchronization
(1st curtain)
Slow shutter speeds are used to brighten
dimly-lit backgrounds.
!SLOW
Slow synchronization
(1st curtain)/Red-eye
reduction ash
Combines slow synchronization with red-eye
reduction.
#SLOW2/
2nd
CURTAIN
Slow synchronization
(2nd curtain)
The ash res just before the
shutter closes to create trails
of light behind moving light
sources.
#FULL Manual (FULL)
*2
For users who prefer manual operation. Flash
output is expressed as a fraction of full power:
1/4, 1/16, or 1/64.
#1/4 Manual (1/4)
*2
#1/16 Manual (1/16)
*2
#1/64 Manual (1/64)
*2
*1 Both the built-in ash and optional external ash units turn off.
*2 Built-in ash only.
4
Press the shutter button all the way.
# Caution
In [!/H(Red-eye reduction ash)], after the pre- ashes, it takes about 1 second
before the shutter is released. Do not move the camera until shooting is complete.
[!/H(Red-eye reduction ash)] may not work effectively under some shooting
conditions.
When the ash res, the shutter speed is set to 1/180 sec. or slower. When shooting
a subject against a bright background with the ll-in ash, the background may be
overexposed.
Flash shooting