Filter
Top Products
92
EN
Information
11
Noise reduction is activated
When shooting night scenes, shutter speeds are slower and noise tends to appear
in images. The camera activates the noise-reduction process after shooting at
slow shutter speeds. During which, shooting is not allowed. You can set [NOISE
REDUCT.] to [OFF]. g “Custom menu” (P. 78)
The date and time has not been set
The camera is used with the settings at the time of purchase
The date and time of the camera is not set when purchased. Set the date and time
before using the camera. g “Setting the date/time” (P. 7)
The battery has been removed from the camera
The date and time settings will be returned to the factory default settings if the
camera is left without the battery for approximately 1 day. The settings will be
cancelled more quickly if the battery was only loaded in the camera for a short time
before being removed. Before taking important pictures, check that the date and
time settings are correct.
Set functions are restored to their factory default settings
When you rotate the mode dial or turn off the power in a shooting mode other than P,
A, S, or M, functions with changes made to their settings are restored to the factory
default settings.
Image taken appears whitish
This may occur when the picture is taken in backlight or semi-backlight conditions.
This is due to a phenomenon called fl are or ghosting. As far as possible, consider a
composition where strong light source is not taken in the picture. Flare may occur even
when a light source is not present in the picture. Use a lens hood to shade the lens
from the light source. If a lens hood does not have effect, use your hand to shade the
lens from the light. g “Interchangeable lenses” (P. 98)
Unknown bright dot(s) appear on the subject in the picture taken
This may be due to stuck pixel(s) on the image pickup device. Perform [PIXEL
MAPPING]. If the problem persists, repeat pixel mapping a few times.
g “Pixel mapping - Checking the image processing functions” (P. 96)
Functions that cannot be selected from menus
Some items may not be selectable from the menus when using the arrow pad.
Items that cannot be set with the current shooting mode
Items that cannot be set because of an item that has already been set:
Combination of [j] and [NOISE REDUCT.], etc.
•
•
•
•
•