Filter
Top Products
122
EN
10
Shooting tips and maintenance
Subjects that are difficult to focus on
It may be difficult to focus with auto focus in the following situations.
In any situation, focus on something with high contrast that is at the same distance as the
subject, determine the composition and shoot the picture. g“Composing and taking a
picture after locking the focus (focus lock)” (P. 50)
Image taken appears whitish
This may occur when the picture is taken in backlight or semi-backlight conditions. This is
due to a phenomenon called flare or ghosting. As far as possible, consider a composition
where strong light source is not taken in the picture. Flare may occur even when a light
source is not present in the picture. Use a lens hood to shade the lens from the light source.
If a lens hood does not have effect, use your hand to shade the lens from the light.
g“Interchangeable lenses” (P. 129)
Unknown bright dot(s) appear on the subject in the picture taken
This may be due to stuck pixel (s) on the image pickup device. Perform [PIXEL MAPPING]. If
the problem persists, repeat pixel mapping a few times. g“Pixel mapping k Checking the
image processing functions” (P. 126)
Functions that cannot be selected from menus
Some items may not be selectable from the menus when using the arrow pad.
• Items that cannot be set with the current shooting mode
• Items that cannot be set because of an item that has already been set:
Combination of [j] and [NOISE REDUCT.], etc.
Camera vibration when the power is turned off
This is due to the camera initializing the image stabilizer mechanism. Without this
initialization, the image stabilizer may not be able to achieve the proper effect.
Set functions are restored to their factory default settings
When you rotate the mode dial or turn off the power in a shooting mode other than
P
,
A
,
S
,
M
or
n
functions with changes made to their settings are restored to the factory default settings.
AF confirmation mark is
blinking.
These subjects are not
focused.
Subject with low contrast Excessively bright light in
center of frame
Object with no vertical
lines
AF confirmation mark
lights up but the subject
is not focused.
Subjects at different
distances
Fast-moving subject
Subject not inside AF area
s0026_e_00_0_unified.book Page 122 Tuesday, September 29, 2009 10:30 AM