Filter
Top Products
E-57
Dubbing
Use the dubbing function to copy the contents of S-
VHS (or VHS) cassettes onto DV cassettes or
record the television.
1 Connect this unit to a video deck or a
television. (Page 54)
2 Press the CAMERA/VCR button and switch to
the VCR mode.
3 Turn on the power of the external unit, and play
back the tape.
4 To start recording video signals from the
connected devices, press two VCR REC
buttons at a time.
On the remote control, while pressing the REC
button, press the PLAY button.
• If you press these two buttons during pause,
the unit will go to shooting standby mode.
Each time the [h] button of the OPERATION
lever is pressed, the unit switches between
shooting and the shooting standby mode.
5 Move the OPERATION lever [g] to stop
recording.
6 Stop playback on the external unit.
Analog/digital (AD) conversion
You can use this unit to convert analog to digital
signals. In the setup menus, AV IN/OUT SETUP
screen, set DV OUT to “ON”. (Page 74)
This enables you to output digital images, which
were input as analog signals from an external unit,
through this unit’s DV connector to another digital
video unit.
• Normally, set DV OUT to “OFF”. Images may be
disrupted if you set it to “ON”.
• You can also use an S-video cable.
• Connecting external units (Page 52)
Analog input
You cannot adjust the audio level.
CAMERA
VCR
COUNTER
RESET TITLE
STILL ADV
PAUSE
STILL ADV
INDEX
— VOL +
STOP INDEX
MULTI/
P-IN-P
REC A.DUB
PLAY/REW FF/
ZOOM
VCR REC buttons
Camera or remote control
Analog signals
Digital signals
Video deck, etc.
Other digital video
unit
This camera-
recorder
AG-DVX100B_EN.book 57 ページ ２００５年１０月５日 水曜日 午前１０時５２分