Filter
Top Products
Operating Instructions
[For assistance, please call: 1-800-272-7033] 125
3.1.7 Resetting the Camera to Factory Default
All camera settings are reset to factory default directly after the Execute button is
clicked. To restore the wireless connection, access the camera by using the wired
connection and set up the wireless configuration. (see page 17 of the Installation/
Troubleshooting)
1. Click [Reset to Factory Default] on the Maintenance page.
2. Click [Execute].
• The indicator blinks orange, and then turns off for 10 seconds.
• All camera settings (user name, password, IP address, subnet mask etc.)
are reset to factory default.
• If the camera is reset to factory default, the network connection mode
changes to [Automatic Setup]. Reconfigure the camera seeing
Installation/Troubleshooting.
Notes
• The internal clock will not be reset, but the time format will return to AM/
PM mode (see page 68). Set it again.
• See page 133—page 140 for default settings.
• Pressing the FACTORY DEFAULT RESET button resets the camera to
the factory default (see page 132).
• All buffered images on the internal memory are deleted when resetting the
camera to factory default. The buffered images on the SD memory card
are not deleted.
• The reset operation takes about 1 minute.
• Do not turn off the camera during the reset operation.