Filter
Top Products
Operating Instructions
40
Basic
(1) Network (IPv4) Configures the IPv4 network settings to connect the
camera to the network (see page 42).
(2) Network (IPv6) Configures the IPv6 network settings to connect the
camera to the network (see page 47).
(3) IPsec Enables IPsec (Transport or Tunnel mode) (see page 51).
(4) Wireless Configures wireless network (see page 61).
(5) UPnP Enables automatic port forwarding or shortcut to the
camera (see page 64).
(6) Viewnetcam.
com
Registers with the Viewnetcam.com service (see page 66).
(7) Date and Time Sets the date and time, automatic time adjustment and
adjust clock for daylight saving time settings (see page 68).
(8) Camera Sets camera name, white balance, pan/tilt range, return to
specified position and color night view settings (see page
71).
(9) Audio Sets output, volume, PC audio input timeout, input, camera
microphone sensitivity and mute during pan/tilt settings
(see page 75).
Account
(10) Administrator
*1
*1
If you change [Administrator], [General User], or [Multi-Camera Setup page] settings,
changes will not be applied to the video (Motion JPEG) viewers. Restart the camera to make
changes applied to all video viewers.
Sets authentication setting and administrator security (user
name and password) (see page 77).
(11) General User
*1
Sets general user security (user name and password) and
general user's access level (see page 81).
Advanced
(12) Image Display Sets resolution, image quality and refresh interval of Single
Camera and Multi-Camera page, time stamp setting, and
language (see page 84).
(13) Multi-Camera
*1
Sets the camera IP address or host name, camera name on
the Multi-Camera page (maximum 12 cameras) (see page
87).