Filter
Top Products
Operating Instructions
[For assistance, please call: 1-800-272-7033] 63
Notes
• Some wireless devices do not support the WEP 152 bit.
• The camera supports only the open system authentication. If the wireless
router or access point is set to shared key authentication, set it to auto or
open system.
4. Click [Save] when finished.
• New settings are saved.
• When finished, "Success!" is displayed.
5. Click [Go to Wireless configuration page].
• The Wireless page is displayed.
Notes
• Encryption is a help to avoid being read the data within wireless LAN by
others.
• Enter both the MAC addresses for the camera itself and the camera's
wireless module to enable the MAC address filtering feature on the
wireless router. The wireless module MAC address is one value higher
than the camera MAC address.
• It takes about 1 minute for the new settings to be effective.
• It is not possible to access the camera simultaneously by both wired and
wireless connection.
• To use the wireless connection, first access the camera by using the wired
connection and configure the wireless settings. Then, disconnect the
Ethernet cable and turn the power off and on.