Filter
Top Products
Others
98
VQT1B86
[SOME PICTURES CANNOT BE
COPIED]/[COPY COULD NOT BE
COMPLETED]
The following pictures cannot be copied.
•When a picture with the same name as
the picture to be copied exists in the copy
destination.
•Files not based on the DCF standard.
Moreover, pictures recorded or edited by
other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you
format the built-in memory on the PC or
remove the batteries without turning the
camera off. Format the built-in memory on
the camera again. (P84) The data on the
built-in memory will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The card format cannot be recognized by
the camera. Format the card again with the
camera after saving necessary data on a
PC etc. (P84)
[PLEASE TURN CAMERA OFF AND
THEN ON AGAIN]
This message appears when the camera is
not operating properly. Turn the camera off
and on. If the message persists, contact the
dealer or your nearest Service Center.
[MEMORY CARD PARAMETER ERROR]
Use a card compatible with this unit. (P5, 13)
•You can only use an SDHC Memory Card
if using cards with 4 GB or more capacity.
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
•An error has occurred accessing the card.
Insert the card again.
[READ ERROR
PLEASE CHECK THE CARD]
An error has occurred reading the data.
Insert the card again. Make sure the card is
inserted properly and then play back again.
[WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred writing the data.
Turn the camera off and remove the card.
Insert the card again and turn the camera
on. Make sure the camera is turned off
before removing or inserting the card to
avoid damage.
[MOTION RECORDING WAS
CANCELLED DUE TO THE LIMITATION
OF THE WRITING SPEED OF THE
CARD]
•When you set the picture quality to
[30fpsVGA] or [30fps16:9], we
recommend using a high speed SD
Memory Card with “10MB/s” or greater
displayed on the package.
•Depending on the type of SD Memory
Card or SDHC Memory Card, recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there
are no remaining folder numbers that can
be used. (P86)
Format the card after saving necessary
data on a PC etc. (P84)
If you execute [NO.RESET] in the [SETUP]
menu after formatting, the folder number is
reset to 100. (P19)
[PICTURE IS DISPLAYED FOR 4:3 TV]/
[PICTURE IS DISPLAYED FOR 16:9 TV]
•The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete
this message at once.
•Select [TV ASPECT] in the [SETUP]
menu to change the TV aspect. (P20)
•This message also appears when the
USB connection cable is connected to the
camera only.
In this case, connect the other end of the
USB connection cable to a PC or a printer.
(P85, 88)