Filter
Top Products
45
VQT1C63
Advanced-Shooting
Shooting with the Intelligent ISO mode
The camera detects movements of the
subject near the center of the frame and
sets the optimum ISO sensitivity and
shutter speed according to the movements
and brightness.
1 Press [MENU/SET].
2 Press e/r to select [ISO LIMIT]
and then press q.
3 Press e/r to select the menu
item and then press [MENU/SET].
Item Content
400 The camera raises the ISO
sensitivity up to the level you have
set to match the movement and
brightness of the subject.
800
1250
• The higher you raise the ISO sensitivity,
the less chance there is of the subject
blurring, but picture noise will increase.
• When shooting a moving subject indoors,
you can reduce blur by raising ISO
sensitivity and increasing the shutter
speed.
1/125 ISO800
• When taking pictures of a motionless
subject, you can reduce noise by setting
ISO sensitivity at a low level.
1/30 ISO200
• When you press the shutter button
halfway, [ ] appears. When you press
the shutter button fully, the shutter speed
and the ISO sensitivity appear for a while.
• Focus range is 5 cm (0.16 feet) (Wide)/30
cm (0.98 feet) (Tele) to Z.
•
ISO sensitivity can be raised to a maximum
of [ISO640] when using the fl ash (when
ISO Limit is set to anything other than
[ISO400]).
• Refer to P42 for the available fl ash range.
• Brightness or the subject’s moving speed
may cause pictures to blur.
• Movement detection may not be possible
in the following cases.
– When the moving subject is too small
– When the moving subject is on the
edge of the frame
– In case the subject began to move the
moment you pressed the shutter button
fully
• To avoid picture noises, we recommend
reducing the [ISO LIMIT] or setting [COL.
MODE] to [NATURAL] (P66).
• You cannot use the digital zoom.
ISO
F2.8
ISO
F2.8
ISO
F2.8
ISO
AWB
MENU
1
/
3
4:3
400
800
1250
ISO
MAX
REC
SELECT SET
W.BALANCE
ISO LIMIT
ASPECT RATIO
PICT.SIZE
QUALITY