Filter
Top Products
- 42 -
Enter SSID (Wireless network name) and password of your access point to connect this unit to the
access point.
1 Check the SSID and password of your access point.
≥ The SSID and password of the access point (e.g. a wireless broadband router) you use are
described on the access point device or in its manual. For details, refer to the access point
manual.
2 Tap # [Camera Wi-Fi settings] # [AP mode setup] # [Set
connect. dest.] on the Image App screen and enter the SSID and
password of your access point (Step1).
3 Press the Wi-Fi/WPS button continuously to change
the Wi-Fi mode lamp to [ ].
≥ The Wi-Fi mode lamp [ ] flashes.
≥ Wi-Fi mode lamp [ ] will turn on when the connection is completed.
2 Connecting this unit and a device on the network
1 Connect a smartphone or a DLNA-compatible device to the access
point.
≥ Connect with an SSID connection or a WPS connection. For information on the connection
method, refer to the operating instructions for your device or access point.
2 When connecting to the smartphone
From the Image App, tap # [Set connect. dest.], and tap this
unit from the connection destination list.
≥ When the connection is complete, control this unit from the Image App.
When connecting with a DLNA-compatible device
On the DLNA device, select this unit from the list of devices that are
connected to the access point.
≥ Refer to the operating instructions of your DLNA-compatible device.
≥ Refer to page 43 for how to play back on a DLNA-compatible TV.
≥ An access point connection cannot be started during motion picture recording.
≥ To disconnect from the access point, press the Wi-Fi/WPS button and turn off the Wi-Fi mode
lamp.
≥ When the Wi-Fi mode lamp of this unit switches, the connection between this unit and the
smartphone is cancelled.
Entering SSID to connect to an access point
Preparation: Connect this unit with the smartphone. (l 17)
HX-A100_VQT4X97.book 42 ページ ２０１３年２月１４日 木曜日 午後２時１６分