Filter
Top Products
- 57 -
If this unit is not operating correctly, take note of the alert sound to resolve any problems.
Alert Sound
“2 Beeps” sound 4 times
≥ If the power is ON, the time of this unit has not been set. Set the date and time. (l 20)
≥ If the power lamp flashes quickly and the power turns OFF, the following symptoms are
possible.
jThe remaining battery level is low. (Charge the battery.) (l 11)
jThis unit has become hot. (Turn ON the power after while a short while.)
≥ If the access lamp flashes quickly, the microSD card is defective. (Includes limit of card
capacity, data errors, etc.)
The status of this unit can be checked by directly connecting to a smartphone, or on the Image
App. (The status of this unit will be displayed as a message.)
“3 Beeps” sound and the Wi-Fi connection disconnects
≥ The connection environment has become worse. Move this unit closer to the connected device.
“4 Beeps” sound and Wi-Fi mode disconnects
≥ Wi-Fi mode disconnects automatically if Wi-Fi mode has not connected for approximately 30
minutes.
“1 Beep” sounds 8 times and live broadcasting does not start
≥ Cannot connect to the connection destination for live broadcasting. Check the settings (SSID or
password), and communication environment (signal conditions or whether the Wi-Fi mode is
correct).
(l 35)
“2 Beeps” sound 8 times and live broadcasting does not start
≥ This unit cannot log in to “LUMIX CLUB”. Check whether the settings (login ID/password,
synchronisation of setting details with this unit) are correct and the “LUMIX CLUB” site has
some problems. (l 31)
“3 Beeps” sound 8 times and live broadcasting does not start
≥ This unit cannot log in to “USTREAM”. Check whether the settings (login ID/password) are
correct and the “USTREAM” site has some problems. (l 31)
“4 Beeps” sound 8 times and live broadcasting does not start
≥ There is a problem with the “USTREAM” site. Check that multiple live broadcasts are not being
performed with the same ID, that there are no problems with the programme set for
broadcasting, that the data communication speed is sufficient, and that this unit clock is set
correctly.
“1 Beep” sounds 8 times and cannot connect to the access point
≥ Check the access point settings (SSID or password), and communication environment (whether
the signal or Wi-Fi mode are correct).(l 41)
HX-A100_VQT4X97.book 57 ページ ２０１３年２月１４日 木曜日 午後２時１６分