Filter
Top Products
Operating Instructions
20
2.3 How to turn on Network Camera for
Installation
Network Camera is powered up when connecting AC plug to the power outlet.
1. Connect Category 5 straight/cross cable to the Ethernet port of Network
Camera to the hub or PC.
• Connect Ethernet cable first to make Network Camera recognize the wired
communication.
2. Connect the DC plug of the AC adaptor to the DC IN jack and the AC plug of
the AC adaptor to the power outlet to turn on Network Camera. Indicator blinks
and the Pan/Tilt moves to the center position.
Notes
• AC adaptor is used as the main disconnect device, so ensure that the
power outlet is located/installed near the equipment and is easily
accessible.
• Use only the specified Panasonic AC adaptor PSLP1233 (Order No.
PSLP1233Z).
• When you set up Network Camera in [Type 3], connect it temporarily in
[Type 1], [Type 2] or [Type 4].
• When Indicator is orange, ensure that the Ethernet cable is properly
connected, or PC, Ethernet hub or broadband router is properly working.
DC IN
jack
AC adaptor
Power
Outlet
Ethernet
port
DC Plug
1.
2.
Category 5 straight/cross cable
To Network