Filter
Top Products
\ZOOM switch
This is used to select motor-driven zoom
operations or manual zoom operations.
SERVO:
For motor-driven zoom operations
(At this position, do not attempt to perform
manual zoom operations or malfunctioning
may result.)
MANU:
For manual zoom operations
]START/STOP button (on the handle)
When this button is pressed in the camera
mode, shooting start or stop is selected.
The camera mode and VCR mode are
switched using the CAMERA/VCR button >.
^REC CHECK button
When this button is pressed in the shooting
pause mode, the picture and sound
immediately before shooting was stopped are
played back for several seconds, and the
shooting pause mode is established at the
original position on the tape.
_Zoom button
When the ZOOM switch is at the SERVO
position, motor-driven zoom operations are
performed.
When this button is pressed lightly, zoom
operations are performed at a low speed;
when it is pressed with force, they are
performed at a high speed.
`Zoom button (on the handle)
aHANDLE ZOOM switch
This switch is used to select one of the three
speeds for the zoom operations conducted
using the zoom button ` on the handle.
The speed is set using the HANDLE ZOOM
item on the setting menu SW MODE screen.
(See page 40)
`a ]
_
^
bAUDIO DUB button
When the pause status is established in the
VCR mode and this button is pressed, the
mode in which audio dubbing can be started
is established.
Press “
;
” of the OPERATION lever U to
record the sound. To stop the recording, tilt
the OPERATION lever in the “
$
” direction.
The audio input used for audio dubbing is set
using the A DUB INPUT item on the setting
menu AV IN/OUT SETUP screen. (See page
44)
OBefore proceeding with the audio dubbing,
select “12 bit” as the AUDIO REC item
setting on the setting menu RECORDING
SETUP screen and then start shooting.
(See page 43)
cVCR REC buttons
When these two buttons are pressed at the
same time in the stop status of the VCR
mode, the video signals from the connected
component are recorded.
When they are pressed at the same time in
the playback pause status of the VCR mode,
the recording standby status is established.
Each time “
;
” of the OPERATION lever U is
pressed, the status alternates between
recording and recording standby.
To stop recording, tilt the OPERATION lever
in the “
$
” direction.
OBefore proceeding to record, check that the
video signals have been input.
dAUDIO MON/VAR buttons
These buttons are used to adjust the volume
at which the sound is to be output from the
internal speaker g or PHONES jack 6.
They cannot be adjusted in the camera
mode.
The playback direction and playback speed
are changed in the variable speed search
mode. (See page 59)
When these buttons are pressed in the pause
status, the tape is played back frame by
frame.
b
d
c
\
ZOOM
SERVO MANU
15
Parts and their functions