Filter
Top Products
Record mode
29
LSQT0862
Recording still pictures on a card
while recording image onto a tape
You can record still pictures while recording
image onto a tape.
≥Set to Tape Recording Mode.
1 Press the [PHOTO SHOT] button fully while
recording image onto a tape.
≥For the number of still pictures to be recorded
on a card, refer to
-80-.
≥When recording pictures onto a card, the
recording start/stop button is disabled.
≥You can select a picture quality for still pictures
to be recorded. (
-31-)
≥In tape recording mode, the size of pictures that
can be recorded is [640].
≥In order to record higher quality still pictures,
you must use the card recording mode.
≥If the wide mode is used, you cannot record
images onto the card.
≥The [PHOTO SHOT] button does not work if it is
pressed halfway.
Check the recording
The last image recorded is played back for 2 to
3 seconds. After checking, the Camcorder will be
set to a recording pause.
≥Set to Tape Recording Mode.
1 Press the joystick during the recording
pause until the icon 1 appears.
2 Move the joystick down to select the
recording check icon [ ].
Blank search function
Searches for the last part of the image recorded
(unused part of the tape).
≥Set to Tape Recording/Playback Mode.
1 Set [BASIC] or [ADVANCE] >>
[BLANK SEARCH] >> [YES].
ª
Stopping a blank search midway
through
Move the joystick down.
≥If the cassette tape has no blank part, then the
Camcorder will stop at the end of the tape.
≥The Camcorder stops at a point approx.
1 second before the end of the last image
recorded. When you start recording at that
point, the image can be recorded seamlessly
from the last image.
PHOTO
SHOT
1
LSQT0862ENG.book 29 ページ ２００４年１２月２１日 火曜日 午後５時９分