Filter
Top Products
Menu
64
LSQT0862
Menus related to taking pictures
ª [H.SHOE MIC]
Set to [LOWCUT] and this reduces low sound
noise and wind noise hitting the stereo zoom
microphone (VW-VMH3; optional) mounted on
the smart accessory shoe.
ª
[DATE/TIME]
This switches between date and time indications.
≥The Camcorder automatically records the date
and time the picture was taken on the tape.
≥You can also show or change the date/time
indication by repeatedly pressing the [DATE/
TIME] button on the remote control.
ª
[AUDIO REC]
Switches the audio (PCM audio) recording
systems.
[12bit]: Records audio in “12 bit 32 kHz 4 tracks”.
(The original audio signals can be kept
after the other audio signals are dubbed.)
[16bit]: Records audio in “16 bit 48 kHz 2 tracks”.
Audio can be recorded in higher quality.
(If audio signals are dubbed, then the
original audio signals will be erased.)
ª
[REC LAMP]
Set to [ON] and this turns the recording lamp on
during recording, which indicates that recording is
underway. Set to [OFF] and this does not turn on
the lamp even when recording is underway.
ª
[DISPLAY]
Set to [ON] and the display mode can be switched
to all functions. Set to [OFF] and it can be
switched to minimum display.
ª
[BEEP SOUND]
Set to [ON] and confirmation/alarm beeps are
issued as follows.
1 Beep
≥When you start recording
≥When you turn on the power
2 Beeps
≥When you pause recording
2 Beeps for 4 times
≥When a cassette with its erasure prevention tab
set to [SAVE] is inserted, condensation occurs,
and at other times. Check the sentence
displayed on the screen.
Menus related to playback
ª [AV JACK]
This switches among the output settings of the
AV/headphone terminal.
[IN/OUT]: Use this setting when inputting signals
from other equipment via an AV cable
or a S-Video cable.
[OUT/Ë]: Automatically switches between AV
and headphone output.
[OUT]: Use this setting when image or sound
is not output normally to the TV in
[OUT/Ë].
≥When using the headphone, set to [SETUP] or
[BASIC] >> [AV JACK] >> [OUT/Ë]. If set to
[OUT], you may hear noises on the right.
ª
[REC DATA]
Set to [ON] and the settings (shutter speed, iris/
gain values, and white balance settings (
-38-),
etc.) used during the recordings are displayed
during playback.
≥When the [AUTO/MANUAL/FOCUS] switch is
set to [AUTO], the indication [AUTO] will
appear.
≥When there is no data, [---] appears on the
display.
≥If the Camcorder data of the Camcorder are
played back on other equipment, the settings
information is sometimes not displayed
normally.
ª
[AUDIO OUT]
This switches the sound to be played back.
[STEREO]: Stereo sound (main sound and sub
sound)
[L]: Left channel sound (main sound)
[R]: Right channel sound (sub sound)
LSQT0862ENG.book 64 ページ ２００４年１２月２１日 火曜日 午後５時９分