Filter
Top Products
17
VQT0T50
When this unit is purchased, the battery is not charged. Charge the battery before using this unit.
¬Set the power switch to [OFF]. (P18)
Connect the AC adaptor (supplied) A
to this unit and the AC outlet.
1 Open this unit’s terminal cover.
2 Connect the AC adaptor to this unit’s DC
input terminal [DC IN 9.3V].
3 Connect the AC mains lead to the AC
adaptor, then the AC outlet.
The status indicator B starts blinking in red at
intervals of about 2 seconds to signal that
charging has commenced. Charging is
completed when the lamp goes off.
≥ If the status indicator blinks faster or slower,
refer to page 106.
∫ Connecting to the AC outlet
If you turn on this unit while charging the battery using the AC adaptor, you can use the
power supplied from the AC outlet to power the unit for use. (While it is in use, the
battery will not be charged.)
∫ Charging time and recordable time
The times shown in the table below show the times at a temperature of 25 oC (77 oF)
and a humidity of 60%. This is just a guide. If the temperature is higher or lower than
the specified value, the charging time will become longer.
≥ The intermittent recordable time refers to recordable time when the recording and
stopping operations are repeated. In reality, it may be shorter than this.
≥ “1h 30 min” indicates 1 hour 30 minutes.
Charging the Battery