Filter
Top Products
56
VQT0T50
You can record still pictures on an SD card using the timer.
¬Rotate the mode dial to select .
1 Press the button in the center to
display the icon shown in the figure.
2 Press the cursor button
left
to select
the [Ø] self-timer icon.
The [Ø
10
] icon flashes orange, then lights
white.
≥ Each time the left cursor button is pressed, the
indication changes by one setting in the
following order: [
Ø
10
]>[Ø
2
]>setting
cancelled.
–
Ø
10
: Starts recording after 10 seconds
–
Ø
2
: Starts recording after 2 seconds
3 Press the record button.
After the indication lamp and the [Ø
10
] or
[
Ø
2
] indication flash for the time which has
been set, recording will start. After recording,
the self-timer is cancelled.
1 Indication lamp
≥ When the record button is pressed halfway
and then all the way, the subject will be
brought into focus when the record button was
pressed halfway.
≥ When the record button is pressed all the way
at once, the subject will be focused just before
the recording.
To stop the timer midway through
Press the [MENU] button. (The self-timer setting is cancelled.)
Self-timer recording
This is for recording using the timer.
1
≥ By operating the [ON/OFF] switch or
mode dial, the self-timer standby mode is
canceled.
≥ Depending on the time taken to bring the
subject into focus, the recording may take
longer than set to start.
≥ Setting the self-timer to [Ø
2
] is a good
way to prevent image shake when the
record button is pressed while using a
tripod etc.
VQT0T50_PP_ENG.book 56 ページ ２００５年８月３１日 水曜日 午後２時２５分