Filter
Top Products
Others
-57-
5) Recording a fast-moving subject
≥Because the focus lens-inside moves
mechanically, it cannot keep up with the
fast-moving subject.
6) Recording a subject with little contrast
≥Because the Camcorder achieves focus
based upon the vertical lines of an image, a
subject with little contrast, such as a white
wall, may become blurry.
ª Time Code
Time Code signals are data that indicate time
measured in hours, minutes, seconds, and
frames (30 frames per second). If this data is
included in a recording, an address is assigned to
each image on the tape.
≥The Time Code is automatically recorded as a
part of the sub-code at each recording.
≥When a new (previously unrecorded) Cassette
is inserted, the Time Code automatically starts
from zero. If a recorded Cassette is inserted,
the Time Code picks up from the point where
the last scene was recorded. (In this case, when
the Cassette is inserted, the zero display
[0h00m00s00f] may appear, but the Time Code
starts from the previous value.)
≥The Time Code cannot be reset to zero.
≥Unless the Time Code is continuously recorded
from the beginning of a tape, accurate editing
may not be possible. To ensure that the Time
Code will be recorded with no breaks, we
recommend the use of the Blank Search
Function (
-22-) before recording a new scene.
ª Memory Stop Function
The Memory Stop Function is useful for the
following operations.
Rewinding or fast-forwarding a tape to a
desired position
1 Set [DISPLAY] >> [C.DISPLAY] >>
[MEMORY].
2 Reset the Tape Counter to zero at the tape
position from which you want to play it
back later. (
-12-, -19-)
3 Start playback or recording.
4 After playback or recording has finished:
Set the Camcorder to Tape Playback Mode.
5 Rewind the tape.
≥The tape automatically stops approximately
at the position where the counter was set to
zero.
Stopping editing automatically during audio
dubbing
1 Set [DISPLAY] >> [C.DISPLAY] >>
[MEMORY].
2 Reset the Tape Counter to zero at the
position where you want to stop editing.
3 Play back the still picture where you want to
start audio dubbing.
4 Start audio dubbing. (-37-)
≥Audio dubbing automatically stops at the
position where the counter was set to zero.
PV-GS33PP_Eng.book 57 ページ ２００４年２月２６日 木曜日 午後５時２９分