Filter
Top Products
Recording
Recording motion pictures
39
LSQT1052
≥ The maximum number of scenes on a disc
(per side): 999 (Even if there is remaining capacity
for recording (on a disc), you may not be able to
record 999 scenes.)
≥ While “WRITING THE INFORMATION ON THE
DISC.” is displayed, do not disconnect the AC cable
or remove the battery as doing so may make the
disc unusable.
≥ Sound is recorded in Dolby Digital from the internal
stereo microphone on the front of the unit. Take
care not to block this microphone.
≥ Each time the unit enters the recording pause
mode, the counter display will be reset to
“0h00m00s”.
A Remaining time left for recording
(When the remaining time is less than 1 minute, [R 0h00m]
flashes red.)
B Recording mode
C Recording time elapsed
≥ While motion picture recording is in progress, do not
disconnect the battery or AC adaptor. If you do, a
repair disc message may be displayed when the
power is turned back on. (l 100, About recovery)
Screen indications in the disc recording mode
R 0h02m
R 0h02m
R 0h02m
0h00m10s
0h00m10s
0h00m10s
SP
A
B
C
Immediately after recording finishes the ACCESS/PC lamp lights. While it lights, the disc is
rotating and disc information is being recorded. If you run while holding the unit or swing it, the
recorded images may be distorted so do not strongly shake or cause impact to it.
LSQT1052(ENG).book 39 ページ ２００５年１２月２１日 水曜日 午後６時５０分